To configure an LACP EtherChannel and number it as 44, configure it between switches SW1 and SW2 using interfaces Ethernet0/0 and Ethernet0/1 on both sides, configure the EtherChannel as a trunk link, configure the trunk link with 802.1q tags, and configure VLAN 'MONITORING' as the untagged VLAN of the EtherChannel, you need to follow these steps:
On both SW1 and SW2, enter the global configuration mode by using the configure terminal command.
On both SW1 and SW2, select the two interfaces that will form the EtherChannel by using the interface range ethernet 0/0 - 1 command. This will enter the interface range configuration mode.
On both SW1 and SW2, set the protocol to LACP by using the channel-protocol lacp command.
On both SW1 and SW2, assign the interfaces to an EtherChannel group number 44 by using the channel-group 44 mode active command. This will create a logical interface named Port-channel44 and set the LACP mode to active on both ends. The LACP mode must match on both ends for the EtherChannel to form.
On both SW1 and SW2, exit the interface range configuration mode by using the exit command.
On both SW1 and SW2, enter the Port-channel interface configuration mode by using the interface port-channel 44 command.
On both SW1 and SW2, configure the Port-channel interface as a trunk link by using the switchport mode trunk command.
On both SW1 and SW2, configure the Port-channel interface to use 802.1q tags for VLAN identification by using the switchport trunk encapsulation dot1q command.
On both SW1 and SW2, configure VLAN 'MONITORING' as the untagged VLAN of the Port-channel interface by using the switchport trunk native vlan MONITORING command.
On both SW1 and SW2, exit the Port-channel interface configuration mode by using the exit command.
On both SW1 and SW2, save the configuration to NVRAM by using the copy running-config startup-config command.
An engineer is configuring data and voice services to pass through the same port. The designated switch interface fastethernet0/1 must transmit packets using the same priority for data when they are received from the access port of the IP phone. Which configuration must be used?
A)

B)

C)

D)