ラボシミュレーション
最近、ワイヤレスネットワークユーザーは、ハードウェアの障害が原因でアクセスポイント2(AP2)が交換された後、速度とパフォーマンスの問題が発生し始めました。
元のネットワークはコンサルタントの仕様に従ってインストールされ、常に問題なく機能しています。
ネットワーク技術者であるあなたは、状況を評価し、パフォーマンスと接続性の両方を改善するために問題を解決する必要があります。
次の図を参照し、デバイスを調整して、ワイヤレスおよびワイヤードインフラストラクチャに必要な変更を加えてください。
注:問題を解決するために必要なデバイスの最小数を調整します。画像内のすべての青いアイコンはクリック可能です。
シミュレーションが完了したと感じたら、[完了]ボタンを選択してください。






正解:
- Change the speed and duplex settings on AP2 only to 100 and full.
- Change the mode to G on AP2
- Change the channel to 6 on AP2
Explanation:
Since we know that the network was running perfectly before replacing AP2 we should start by looking at this new device that was used to replace the old one. Here we see that the other AP's have hard coded the speed and duplex settings to 100/full, while AP2 is set to auto/auto.
Also, the other AP's have been configured to use 802.11G, while AP2 is using 802.11B.
Finally the channel that AP2 is using overlaps with AP1 which can cause problems.
Channels 1, 6, and 11 are spaced far enough apart that they don't overlap.
On a non-MIMO setup (i.e. 802.11 a, b, or g) you should always try to use channel 1, 6, or 11.
Since AP1 is using 1, and AP3 is using 11, AP2 should be using 6.