エンジニアはルータ上に新しいループバック インターフェイスを設定し、そのインターフェイスを OSPF で fa4 としてアドバタイズする必要があります。このタスクを実行できるコマンド セットはどれですか? A) B) C) D)
正解:A
Step 1. Create the loopback interface using the interface loopback number global configuration command. Step 2. Add a description. Although optional, it is a necessary component for documenting a network. Step 3. Configure the IP address. For example, the following commands configure a loopback interface of the R1 router shown in (shown earlier in the chapter): R1# configure terminal R1(config)# interface loopback 0 R1(config-if)# ip address 10.0.0.1 255.255.255.0 R1(config-if)# exit R1(config)#