2つのレイヤ2スイッチ間に物理接続が実装されており、それらの間のネットワーク接続を構成する必要があります
1. LACP EtherChannelを構成し、1として番号を付けます。両側のインターフェイスEthernet0/0およびEthernet0/1を使用して、スイッチSW1とSVV2の間で構成します。LACPモードは両端で一致する必要があります
2EtherChannelをトランクリンクとして構成します。
3.802.1qタグを使用してトランクリンクを構成します。
4.EtherChannelのネイティブVLANをVLAN15として設定します。

正解:
Answer as below configuration:
On SW1:
conf terminal
vlan 15
exit
interface range eth0/0 - 1
channel-group 1 mode active
exit
interface port-channel 1
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk native vlan 15
end
copy run start
on SW2:
conf terminal
vlan 15
exit
interface range eth0/0 - 1
channel-group 1 mode active
exit
interface port-channel 1
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk native vlan 15
end
copy run start